Publicidad
FUNCTIONS
BACK PANEL
1. LEDs
CLIP: When lit, the input signal level is excessive
and should be reduced.
SIG: When lit, the speaker is receiving an input
signal.
: When lit, the power is on.
2. EQ MODE SELECTOR
Select your desired EQ mode using this dial.
Please see page 6 for further details.
3. MIX OUT
Outputs a full range combined signal. Use this
XLR output to connect an active speaker.
4. INPUT 2 RCA PHONO
Connect an Instrument or playback device via
RCA/Phono.
5. SPEAKER OUT
Outputs a full range, combined signal. Use
this powered 8ohm Speakon (NL4) output to
connect a passive speaker.
6. MASTER LEVEL
Adjust the overall output volume.
7. MIC/LINE SWITCH
Switch between Mic or Line level impedance.
8. INPUT 1 LEVEL
Adjust the level for Input 1.
9. INPUT 1
Connect a microphone or Line level device
using either XLR or 6.3mm TRS Jack. Please
ensure the MIC/LINE switch is set to the correct
position dependant on the device connected.
10. INPUT 2 LEVEL
Adjust the level for Input 2.
11. INPUT 2
Connect a Line level device using XLR.
12. POWER INPUT
Connect the provided AC power cable here.
13. POWER SWITCH
Turns the speaker on or off
5
Publicidad
