Troubleshooting - Westbend JC2009SV13 Manual De Instrucciones

Rated voltage
Rated power
Rated frequency
Continuous Working Time
Interval Working Time
Issue
The power does not
turn on
There is a smell during
first use
The machine stops
working during use
The machine is making
noise
The drum/chute are
difficult to remove.
English - 7
S /P
AFETY RODUCT
T
ROUBLESHOOTING
Possible Causes
1. The power plug is not
plugged in properly.
2. The outlet is not working.
3. The internal cable of the
main unit is off or the circuit
board is damaged.
There is no problem.
1. The voltage is too low
2. Excessive or hard
ingredients being forced
through the chute.
3. The continuous working
time is too long.
1. The auger and fine
strainer are not fully installed,
resulting in unsteady
operation.
2. Too many ingredients
being fed through chute at
one time straining the motor.
1.There is residue on the
surface of the juicer body or
drum/chute.
2. The ingredients are not
fully juiced.
I
NFORMATION
120V
150W
60Hz
≤10 minutes
≥20 minutes
Suggested Resolution
1. Try unplugging and re-
plugging the plug back in.
Also try plugging it into a
different outlet.
It is common for the
machine to possibly have
an odor when first plugged
in during first use. If this
occurs with subsequent
uses be sure that the parts
are well cleaned and there
is no residue.
1. Check the voltage.
2. Disconnect the power
and remove the excess
ingredients.
3 The motor will resume
operation after a break to
cool down.
1. Fully install the auger
and fine strainer.
2. Remove excess
ingredients.
3. Shut machine and let it
cool down.
1. Clean the surface of the
juicing body and
drum/chute.
2. Continue to juice all
ingredients or turn the
power switch to REV for a
few seconds to rotate the
ingredients out of the juice
strainer.