When To Refill The Rinse Aid Dispenser; Adjusting Rinse Aid Dispenser - De Dietrich DC1538QJ Manual De Instrucciones

When to Refill the Rinse Aid Dispenser

If the rinse-aid warning indicator lights up in the control panel, you should refill the rinse aid.
1 1
1
Remove the rinse reservoir cap by lifting up the handle .
2
Pour the rinse aid into the dispenser, being careful not to overfill.
3
Close the cap after all.
NOTE:
Clean up any rinse aid spilled while during filling with an absorbent cloth to avoid excessive foaming
during the next wash. Don't forget to replace the cap before you close dishwasher door.

Adjusting Rinse Aid Dispenser

To achieve a better drying performance with limited rinse aid, the dishwasher is designed to adjust the
consumption by user. Follow the below steps .
1. Power on the dishwasher by plugging in;
2. Within 60 seconds after step 1,press the Program button more than 5 seconds, and then press the
Delay Button to enter the set model, the rinse aid indication blinks as 1Hz frequency.
3. Press the Program button to select the proper set according to your using habits ,
the sets will change in the following sequence: D1->D2->D3->D4->D5->D1,
Dispenser drops more rinse aid in D5 level than in another, the manufactory setting is D3.
4. Without operation in 5 seconds or press the on/off button to exit the set model, the set success.
2 2
NOTE:
Increase the dose if there are drops of water or lime spots on the dishes after washing.
Reduce it if there are sticky whitish stains on your dishes or a bluish film on glassware or
knife blades.
9
3 3