Velleman HAA85 Manual Del Usuario página 5

C) Programming -- Configuration of relay outputs -- Installer programming
Access Keys Code Duration
(Seconds)
4 0 From 1 to 999
4 1
4 2
5 0 From 1 to 999
5 1
5 2
D) Programming -- Safety -- Installer Programming
Access Keys Validation
7 0
7 1
7 2
E) Leave programming mode
Validation Comments
* The keypad leaves programming mode, and is in OPERATION mode, ready for daily
use.
6. The Factory Set Data
For the owner's convenience in programming at the first time, the factory has put a MASTER CODE 0000 into the
keypad. Except that code, no other useful code or data has been put into the keypad. The owner has to put his own
UNIQUE CODES and DATA into the keypad before use.
IMPORTANT NOTE TO OWNER
To compromise security, in all cases, the owner should program a PERSONAL MASTER CODE for his keypad in
order to invalidate the factory set 0000 master code.
PROGRAM THE KEYPAD -- EXAMPLE
1) REQUIREMENTS -- The following data are required to be stored:
a) Change the factory set Master Code 0000 to a Personal Master Code 3289
b) Set User Code 1 in 8321
c) Set User Code 2 in 6854
d) Set relay output 1 in Momentary Mode, 5 seconds
e) Set relay output 2 in Start/Stop Mode without accelerated code
f) Set keypad to lock during 30 seconds after 10 successive false code
HAA85
Validation
#
/ #
/ #
#
/ #
/ #
Comments
# After 10 successive false codes, the keypad locks during 30
seconds.
# After 10 successive false codes, the DURESS output is switching to
ground.
# Disappearance of the 2 above securities.
Comments
Output 1 in MOMENTARY mode from 1 to 999
seconds
Output 1 in START/STOP mode without
accelerated code.
Output 1 in START/ STOP mode with
accelerated code.
Output 2 in MOMENTARY mode from 1 to 999
seconds
Output 2 in START/STOP mode without
accelerated code.
Output 2 in START/ STOP mode with
accelerated code.
5 VELLEMAN