Charging The Battery - Bayan Audio soundbook X3 Manual Del Usuario

Charging the Battery

• Connect the mains power cable to your Soundbook X3.
• Plug the power adapter into a mains outlet.
• The first time you use your Soundbook X3, let it charge for 12 hours to
ensure the built-in Lithium battery is properly conditioned.
When Soundbook X3 detects a low battery state it will display the word
LOW on the front display.
Listening to Bluetooth Music:
• Turn on your Soundbook X3 (open the cover and if necessary press and
hold the Power/input button until your Soundbook X3 turns on – it will
remember the last selected input and go to this automatically).
• If necessary, change the input to BLUE (Bluetooth) – short-press the centre
Power/input button to cycle through the inputs until the display shows
BLUE
English
Connect by NFC – Automatic paring
If your audio source supports NFC, you can use NFC Secure
Simple Pairing to connect your phone to the Soundbook:
• Turn on your audio source and unlock the screen
• Ensure that NFC is enabled in the settings on your audio source
• Touch the back of your audio source to the back cover of your
Soundbook X3 where the NFC logo is located – you will be asked to
confirm that you wish to connect and pair with the Bayan Soundbook
– select Yes/OK.
• You can disconnect by simply touching your audio source again to the
back cover of your Soundbook X3.
Connect by Traditional Bluetooth Pairing
If your audio source does not support NFC but is
1 Bluetooth enabled, you can use Bluetooth Secure
Simple Paring to connect and stream music:
• Consult your audio source user manual for instructions on how to
pair with Bluetooth devices – generally you will need to go into your
settings, Bluetooth, scan for new Bluetooth devices and select 'Bayan
Soundbook' You will not be prompted for a passcode for pairing.
Note:
• For secure simple pairing to work, your MP3 /phone / tablet / laptop
must be in close proximity to your Soundbook X3 when trying to pair
(within a range of 1 metre)
• After pairing is successful, paired devices will remember each other –
unless pairing information is deleted there is no need to carry out pairing
again. Soundbook X3 can remember the last 4 audio sources that it was
paired with
• Soundbook X3 will automatically connect to the last audio source
it was connected to (if it is in range). If you want to connect to an
alternate audio source, switch off Bluetooth on the current connected
audio source, and then pair / connect with the alternate audio source
according to the steps outlined above.
Note:
To achieve the best audio quality, ensure your MP3 recordings are
sampled at a high bit rate (ideally 320kbps Stereo), and your source
device supports aptX digital audio compression.
Bluetooth Status
The Soundbook X3 display additionally
will show the current status of the Bluetooth
connection. The Bluetooth status light (shown
in the diagram) will flash when there is
no Bluetooth audio source connected to the Bluetooth speaker, and will
illuminate solid when a Bluetooth audio source is connected.
Note:
If you are trying to connect your audio source to your Soundbook X3 via
Bluetooth and another device is already connected (e.g. the Bluetooth
status light is illuminated solid), Soundbook X3 will reject your connection
request – you must first disconnect the Bluetooth source that is already
connected to your Soundbook X3.
English