Work Area; Electrical Safety; Personal Safety - Silver Eagle SE1200 Guia De Inicio Rapido

FAILURE TO OBSERVE THESE WARNINGS COULD RESULT IN INJURY
THIS INSTRUCTION
IMPORTANT SAFETY INFORMATION.
READ THIS INSTRUCTION MANUAL CAREFULLY
AND UNDERSTAND ALL INFORMATION BEFORE
OPERATING THIS TOOL.

Work Area

• Keep your work area clean and well lit. Cluttered
benches and dark areas invite accidents. Do not operate
power tools in explosive atmospheres, such as in the
presence of flammable liquids, gases or dust. Power
tools create sparks which may ignite the dust or fumes.
• Keep bystanders, children, and visitors away while
operating power tool. Distractions can cause you to lose
control.

Electrical Safety

• Double insulated tools are equipped with a
polarized plug (one blade is wider than the other).
This plug will fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact a qualified
electrician to install a polarized outlet. Do not
change the plug in any way. Double insulation
eliminates the need for the three wire grounded power cord
and grounded power supply system.
• Avoid body contact with grounded surfaces such as
pipes, radiators, ranges and refrigerators. There is an
increased risk of electric shock if your body is grounded.
• Do not expose power tools to rain or wet conditions.
Water entering a power tool will increase the risk of electric
shock.
• Do not abuse the cord. Never use the cord to carry the
tools or pull the plug from an outlet. Keep cords away from
heat, oil, sharp edges or moving parts. Replace damaged
cords immediately. Damaged cords increase the risk of
electric shock.
• When operating a power tool outside, use an
outdoor extension cord marked "W-A" or "W". These cords
are rated for outdoor use and reduce the risk of electric
shock.
SE1200
All manuals and user guides at all-guides.com
SE1200 1/2" Electric Impact Wrench
MANUAL CONTAINS

Personal Safety

• Stay alert, watch what you are doing and use
common sense when operating a power tool. Do not use
tools while tired or under the influence of drugs, alcohol, or
medication. A moment of inattention while operating power
tools may result in serious personal injury.
• Dress properly. Do not wear loose clothing or jewelry.
Contain long hair. Keep your hair, clothing, and gloves away
from moving parts. Loose clothes, jewelry, or long hair can
be caught in moving parts.
• Avoid accidental starting. Be sure switch is off before
plugging in. Carrying tools with your finger on the switch or
plugging in tools that have the switch in the "on" position
invites accidents.
• Remove adjusting keys or switches before turning the
tool on. A wrench or a key that is left attached to a rotating
part or the tool may result in personal injury.
• Do not overreach. Keep proper footing and balance at all
times. Proper footing and balance enables better control of
the tool in unexpected situations.
• Use safety equipment. Always wear eye protection. Dust
mask, non-skid safety shoes, hard hat, or hearing protection
must be used for appropriate conditions.
2 08/03/06