Installation With Std9 & Std9A Power Supply Units - SAMES KREMLIN STD 9 Manual De Instrucciones

Ocultar thumbs Ver también para STD 9:
Tabla de contenido

Publicidad

5. INSTALLATION WITH STD9 & STD9A POWER SUPPLY UNITS
(REFER TO GENERAL SAFETY INSTRUCTIONS)
A safe electrostatic system installation requires compliance with all applicable safety standards and
requirements outlined in this manual. Any improper installation or misuse of the electrostatic coating
system can cause serious body injury, fire, explosion, or electric shock hazard. The European safety
standard EN 50053 covers installation and operation regulations of electrostatic coating system.
Ind.
Description
A
Main air supply line
B
Air and water separator
C
Air supply shut off valve
D
Air filter with air pressure regulator
E
Atomizing air shut off valve
F
Air pressure regulator (pump)
G
Air supply shut off valve (pump)
H
STD 9 power supply unit
I
Connecting air lines
The typical installation shown above is a guide for selecting and installing an electrostatic coating
system.
Other installations can be used (with diaphragm pump, circulating, heated coating system, etc ..).
For assistance in designing other system, contact your local authorized KREMLIN REXSON distributor.
KREMLIN REXSON
Ind.
J
K M.3 Ex electrostatic manual gun
K Low voltage cable
L
Pump
M
Fluid filter
N
Fluid drain valve
Connecting fluid line
O
Three wire cable (230 V + ground) or (115 V
P
+ ground)
Q
Warning sign
R
Air supply hose of the power supply
Page 9
Description
Manual : 573.162.112

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Std 9 aStd 9 b

Tabla de contenido