Installation Steps; Care And Cleaning - AVS Ventvisor Deflector Instrucciones De Instalación

Installation Steps

Carefully lift the mirror cap cover to create a 1/4" gap.
1/4" gap
3
Align the passenger side visor with the previously
cleaned surface.
5
Press along visor flanges to ensure proper adhesion.
7

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in
terms of fit, durability, finish and ease of installation.
Auto Ventshade
™
NOTE: Actual application may vary slightly from illustrations.
Lund International, Ventshade Accessories Division
655 Raco Drive, Lawrenceville, GA 30045
800-241-7219 • Fax 770-339-5839 • Visit us at lundinternational.com
© 2005 Lund International, Inc. All rights reserved.
, the Auto Ventshade logo and the AVS
TM TM
While lifting mirror cap, insert front flange of visor under-
neath it. Release mirror cap.
4
With the visor in its final position, remove the remaining
tape liner by pulling on free ends.
6
4 Piece Set
8
Repeat Steps 1 - 8 for opposite side
logo are trademarks of Lund International, Inc.
TM
Page 2 of 2
The rear visor attaches with same
preparation methods as the front
visor. Attach visor to the vehicle's
painted surface.
or