Prepare The Water System; Install Cleanflow™ Air Filters - KENMORE ELITE 106.5116 Serie Manual De Uso Y Cuidado

Complete the Installation
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Plug into a grounded 3 prong outlet.
2. Flush the water system. See "Prepare the Water System" or
"Water and Ice Dispensers."
NOTE: Allow 24 hours to produce the first batch of ice. Allow
72 hours to completely fill ice container.

Prepare the Water System

Please read before using the water system.
Immediately after installation, follow the steps below to make
sure that the water system is properly cleaned.
1. Open the freezer door and turn off the ice maker. The On/
Off switch can only be accessed when the ice storage bin
has been removed. The switch is located on the freezer door,
on the left side of the wall that surrounds the ice storage bin.
Move the switch to the OFF (right) setting.
2. Make sure the water filter is properly installed.
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
3. Flush the water system. Use a sturdy container to depress
and hold the water dispenser lever for 5 seconds, then
release it for 5 seconds. Repeat until water begins to flow.
Once water begins to flow, continue depressing and
releasing the dispenser lever (5 seconds on, 5 seconds off)
until a total of 3 gal. (12 L) has been dispensed. This will
flush air from the filter and water dispensing system, and
prepare the water filter for use. Additional flushing may be
required in some households. As air is cleared from the
system, water may spurt out of the dispenser.
All manuals and user guides at all-guides.com
4. Open the freezer door and turn on the ice maker. Move the
switch to the ON (left) position. Please refer to the "Ice
Maker and Storage Bin" section for further instructions on
the operation of your ice maker.
Allow 24 hours to produce the first batch of ice.
Discard the first three batches of ice produced.
Depending on your model, you may want to select the
maximum ice feature to increase the production of ice.
Install CleanFlow™ Air Filters
(on some models)
On some models, your refrigerator's accessory packet includes
two air filters, which must be installed prior to use. On some
models, the air filters are already installed at the factory.
The air filter reduces the buildup of odors. This helps to maintain
a cleaner environment inside the refrigerator.
Installing the Air Filters (on some models)
The filters should be installed in two separate locations.
Location 1:
Install one of the filters behind the vented door, which is located
(depending on your model) along either the rear or left interior
wall near the top of the refrigerator compartment.
1. Remove the air filter from its packaging.
2. Lift open the vented door.
3. Snap the filter into place.
4. Close the vented door.
13