Young America SSC 1400 Instrucciones De Montaje página 7

Step 2:
As shown in Fig. 4, align the holes in (1) of the Base Rails with the holes in the Crib

Ends and insert the connector bolts from the inside of the Base Rail.
Loosely attach the Base Rail to the Crib Ends using (4) 2" connector bolts. Make sure

the Brackets attached to the Base Rail are facing the inside of the Crib.
Secure the connector bolts just enough to hold the Base Rail in place using the provided

wrench.
See Figure 6.
See
Figure 4.
Install (3) Locater Pins, (1) in

the Base Rail and (1) in each
Crib End.
Locate the threaded insert in

the top edge of the Base Rail
and insert a Locater Pin.
Tighten by hand. See Fig. 5.
Locate the upper threaded in-

sert in each of the Crib Ends
and insert a Locater Pin. See
Fig. 6. (Make sure to insert
the Locater Pins on the same
side of the Crib Ends as the
attached Base Rail.)
All manuals and user guides at all-guides.com
Attaching the Crib Base Rail
See
Figure 5.
Figure 5.
Enlarged
View
Base Rail
Figure 4.
Enlarged
View
Threaded
Insert
7
Wrench
Figure 6.
Enlarged
View
Upper
Crib End
Insert
Locater
Pin