Blackstone 1665 El Manual Del Propietario página 8

STEP 5
Take gas regulator off of the griddle body.
STEP 6
Screw in the LP bottle into the gas regulator, turning the
tank clockwise.
The LP bottle should
look like the picture
below when properly
connected to the
regulator.
Make sure to only use
a 3.8 x 7.8inch, 16.4oz
Propane bottle. The LP bottle
to be used must be constructed
and marked in accordance with
the specifications for LP bottles, U.S.
Department of Transportation (DOT) or
the Standard for Cylinders, Spheres and Tubes for the
Transportation of Dangerous Goods, CAN/CSA-B339.
1. Do not store a spare LP gas cylinder under or near
this appliance;
2. Never fill the cylinder beyond 80 percent full.
If the instructions in 1) and 2) are not followed exactly, a
fire causing death or serious injury may occur.
The LP bottle must be disconnected when the griddle is
not in use. Only cylinders marked "propane" may be used.
The LP bottle must be positioned for vapor withdrawal.
8
All manuals and user guides at all-guides.com
STEP 7
Insert the gas regulator and tank into the gas line of the
griddle, then turn the collar of the gas regulator clockwise
to secure it to the gas line.
STEP 8
Place the griddle top on the griddle body. Make sure the
four positioning pegs on the griddle top are seated into
the griddle body.
STEP 9
Attach the grease cup to the back of the griddle top, it
should look like the picture below.
STEP 10
When the installation steps have been completed, your
unit should look like the image below.