All manuals and user guides at all-guides.com
PROBLEM
Pressure reading
It is normal for "some"
on the regulated
pressure drop to occur.
pressure gauge
drops when an
accessory is
used.
Prolonged excessive use of
Compressor is
not supplying
air.
enough air to
Compressor is not large
operate
accessories.
enough for air requirement.
Hole in hose.
Check valve restricted.
Air leaks.
Regulator knob
Damaged regulator.
has continuous
air leak.
Regulator will
Damaged regulator.
not shut off air
outlet.
D28900
CAUSE
If there is an excessive
amount of pressure drop
when the accessory is used,
adjust the regulator following
the instructions in the
"Description of Operation"
paragraph in the "Operation
Section.
NOTE: Adjust the regulated
pressure under flow
conditions (while accessory
is being used).
Decrease amount of air
usage.
Check the accessory air
requirement. If it is higher
than the SCFM or pressure
supplied by your air
compressor, you need a
larger compressor.
Check and replace if
required.
Remove and clean, or
replace.
Tighten fittings.
Replace.
Replace.
20- ENG
CORRECTION