Installation Steps - AVS Stepshield Instrucciones De Instalación

Installation Steps

Open the passenger side front and ex-
tended cab doors. Clean the Stepshield
mounting location.
1
3
With the Stepshield in its final position, remove re-
maining tape liner by pulling on free ends.
4
Repeat steps 1 through 5 for the front Stepshield, aligning flush with the previously installed extended
6
NOTE: Actual application may vary slightly from drawings.
cab Stepshield.
Repeat installation procedure for opposite side Stepshields.
Page 2 of 3
Peel back 2" (5cm) of tape liner from
each end of passenger side extended cab
Stepshield.
2
Align the Stepshield with the previously
cleaned door sill. Be sure the cutout in the
part is properly positioned with the door
latch hardware. Gently press the exposed
areas of the tape against the door sill and
Apply pressure to taped areas to secure.
5
verify position.