Craftsman 3000 Serie Manual Del Operador página 4

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

operatioN
tab style - Depress the release tabs on both sides,
(this allows the slides to ride over the stops.)
Pull out to remove.
friction style - Fully extend the drawer. insert screwdriver
into the slot in the side and push in on the stop until it
clears the lance. Pull drawer just past lance before
releasing stop. Repeat the process for the other slide.
iNstaLLiNG DraWers
Ball bearing slide - Pull slides and slide carrier out to fully
extended position (see illustration.) hold the slide on the
cabinet while aligning it with the slide on drawer. Slightly
insert one side and repeat for the other side. Slowly push
drawer to its fully closed position to engage slide. Open
drawer and reclose to ensure proper operation.
slide carrier
slide
All manuals and user guides at all-guides.com
4
removiNG aND iNstaLLiNG sLiDes
• To remove the slide from the unit, first remove the
drawer.
• After removing the drawer check to see if the unit has
rivets located on the front of the slide. To drill out rivets,
use a 5/32-in drill bit. The rivets will need to be replaced
with 5/32-in rivets.
• Lift and hold the spring retainer and push the slide up-
ward. The slide may now be removed.
• To reinstall the slide in the appropriate position in the
unit, align front and back lances with mounting holes in
the side of the unit. Pull towards the front of the unit and
downwards until the spring retainer snaps into posi-
tion and secures the slide. The rivets will need to be
replaced with 5/32-in rivets.
• For smooth operation, make sure the drawers are
matched with their original slides.
Spring Retainer

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

31293312953129231294

Tabla de contenido