Publicidad
STEP 5
Mark and pre-drill mounting
holes using measurements in
figures 5 and 6. Attach door
mounting brackets using (6)
#6x1/2" flathead screws.
3
#2
32
STEP 6
Align the door brackets to the
slide covers and attach with (2)
1/4-28x1/2" machine screws
and washers (See Fig 7).
#2
INSTALLATION INSTRUCTIONS: 53TM STAINLESS STEEL TOP MOUNT WASTE CONTAINER
5/8" (16 mm)
BETWEEN HOLES
1-7/8" (48 mm)
2-1/2" (64 mm)
14-11/16"
(373 mm)
+ Door
Overlay
13/16" (21 mm)
+ Door Overlay
1)
Make sure that your unit is securely installed into your cabinet. Remove the cabinet door and
hinges to begin to mount your door.
2)
Using the (4) provided screws and nuts, attach the L-Brackets to your slide.
Note: Depending on your particular basket design L-Bracket will mount on either inside or
outside of wire.
Inside wire shown
3a)
Attach the door brackets to the outside of the L-brackets using the (4) provided screws.
FIGURE 5
FIGURE 6
HOW TO DETERMINE YOUR DOOR OVERLAY:
Measure Opening Height ________
Measure Door Height ________
Height Difference ________
Divide Difference by 2 ________ = Overlay
FIGURE 7
3b)
Cad
con la po
dañen su
Chaque p
la partie
à travers
3c)
Se p
dos para a
Des espac
pour atte
4)
Apliqu
soportes m
poco, esto
atornilla lo
Mettez du
supports
tout à fait
3
pendant q
Publicidad
