Heath Zenith 5401 Manual Del Usuario página 2

INSTALLATION
For easy installation, select an existing light operated
by a wall switch for replacement.
IMPORTANT: Avoid mounting light control in an
extremely dark area. This may cause the lights to
stay on all the time.
For best performance, mount the fixture about 8 feet
(2.4 m) above the ground.
1. Drill the holes needed to mount the backplate to
the junction box.
Wire the Light Control
WARNING: Turn power off at the fuse or
circuit breaker.
1. Remove the existing light fixture.
2. Route the light control's wires through the large
gasket hole.
3. Connect the junction box wires to the light control
wires. Twist together and secure with a wire con-
nector.
White to White
Black to Black
All manuals and user guides at all-guides.com
Gasket
Mount the Light Control
IMPORTANT: For under eave installation, the
light sensor needs to face toward the changing
light source.
Eave Mount
1. Align the light control cover plate and the junction
box holes. Secure with the mounting screws.
2. If not installed on a weatherproof box or if an adap-
tor plate (not included) was used, caulk the wall
plate and mounting surface with silicone.
3. Adjust the lamp holders by loosening the lock nuts
but do not rotate the lamp holders more than 180°
from the factory setting. When screwing in the
floodlamps, do not overtighten.
Lock nuts
2
Wall Mount
Avoid water damage and
electrical shock - keep lamp
holders below horizontal.
598-1253-00