How To Listen To The Fm Radio; Wired Audio Input - Midland BTX2 PRO Manual De Instrucciones

› Press and hold down the "Middle" button about 7 sec., until the Red light is on perma-
nently.
› Now press firmly (3 sec) the "Vol +" or "Vol -" button, the Blue and Red light will flash.
› Follow now the pairing procedure explained on the manual of the transceiver itself

How to listen to the FM Radio

The FM Radio receiver is integrated inside the unit. You just need to switch to the "FM Radio"
mode in order to use it. Long press the middle button until you hear "FM radio" from the voice
announcement. Now all the three main buttons are dedicated to the FM Radio (See Table C).
Press short the Forward or the Backward button to seek the FM Radio station. When you
press long the Forward or the Backward button, you can scan up or down the 6 recorded
stations. A voice announcement will tell you the number of which memory you are entering.
To save the station you are listening to, press the Forward and Backward buttons together
for 3 sec. You will hear a beep tone for confirmation.
The station is saved over the last recorded station used.
Thanks to the RDS system, the FM Radio will choose the strongest signal available for the
radio station you like to listen. The RDS system is OFF by default, if needed you can toggle
on/off the RDS pressing together the "Volume +" and "Volume –" buttons for 3 sec when
the radio is on. A voice announcement will tell you the RDS status.
How to Disable/Enable the FM Radio
By default the FM radio is on.
Disabling:
› Enter the "Setup" mode: turn off the unit and hold down the "Middle" button about 7
sec., until the Red light is on permanently.
› Press "Middle" and "Volume+" buttons together for 3 seconds. The blue LED will flash
three times.
C-Radio FM mode
Mode
FM Radio
www.midlandeurope.com
All manuals and user guides at all-guides.com
Forward button
Short press: seek station up
Long press: Scan recorded
› Double click on the "Middle" button to exit the "Setup" mode and use the Midland BTX2
PRO
Enabling:
› Follow the same procedure up described; now the blue LED will flash once.
To exit the "Setup" mode, double click the "Middle" button.
FM Radio with intercom
When you are in "FM Radio" mode is not possible to manually open the intercom, you can
only open it using VOX feature (just talk) to the unit paired on the "Middle" button. To
manually activate the intercom you must switch to "Intercom" mode.

Wired audio input

Your Midland BTX2 PRO can be connected to a wired audio source, like an iPod (or any
other MP3 Player).
Listening to music
To listen to music from the wired input, connect the audio source using the optional AUX
cable. The volume buttons (Vol + and Vol -) can be used to adjust the volume of the wired
audio source (but not independently from the Intercom Volume). The AGC system will
automatically increase the volume on higher speed.
Attention: never set the volume of the MP3 Player to the maximum possible. Normally the
best level is about the 70% of the maximum.
Hint: We recommend that you perform a few tests adjusting the volume of your iPod/MP3
player so at the normal speed the Headset volume is suited to your needs. The AGC system
will automatically increase the volume on higher speed, so you don't need the VOL+ or VOL-
buttons to adjust it.
Middle button
Short press: On/off
Long press: Change mode
Rear button
Short press: seek station up
Long press: Scan recorded
29