Famastil LV1800 Manual De Instrucciones página 37

17
Turn on the pressure washer. Pull trigger to operate unit. The liquid detergent will
04
automatically mix with water, and be discharged through the nozzle at low pressure.
Apply detergent to a DRY work surface, from bottom to top.
Allow detergent to remain on the surface for a short time before rinsing. Do not
05
allow detergent to dry on surface.
Rinse with clean water under high pressure. On a vertical surface, rinse from the
06
bottom up, then rinse from the top down to avoid streaking. Hold nozzle 6-8" (15-20
cm) from the work surface, at a 45° angle.
When you have finished using the detergent injection system, fill detergent bottle
07
with clean water. Siphon water at low pressure for one minute, so that all detergent
is flushed through system. Remove detergent bottle, and rinse it thoroughly.
CAUTION! Damage may occur to painted surface if chemical is
allowed to dry on surface. Wash and rinse a small section at a
time. Avoid working on hot surfaces or in direct sunlight.
SHUTTING DOWN AND CLEANING
01 (If you're not using detergent go straight to step number 2). Once you finish using
the detergent on the surface, fill the detergent dispenser with clean water. Keep
water running at low pressure for one minute, so the water will come out from the
compartment.
02 Unplug the Washer directing the switch to "0" position.
Unplug the power cord from the mains.
03
04 Turn off the tap.
Press the gun trigger to empty the water.
05
06 Disconnect the hose that supplies water to the washer.
Pull the trigger safety lock.
07
All manuals and user guides at all-guides.com
19
03 Remove the lid and place
the detergent. Close the
lid. It is advisable to supply
the compartment with 50%
detergent and 50% water,
as this will cause the foam
to create while leaving the
compartment. Firstly fill the
compartment with detergent,
than put the water.
37