In The Event Of Problems; Disposal - Beurer babycare BY 84 Instrucciones Para El Uso

• After use, before cleaning and changing
any accessory parts, the power unit should
always be disconnected.
• If dirty, wipe the device with a soft, dry cloth.
• Clean the devices with a dry cloth.
• Do not use any abrasive cleaning products.

11. In the event of problems

Faults Action
Displays do Check whether
not illuminate • the relevant adapter plug is properly
after switching plugged in,
on. • the batteries are charged/not too
weak,
• the batteries have been correctly
inserted.
No acoustic Check that
signal is trans- • the transmitter is switched on,
mitted by the • the same pilot tone setting was
receiver. selected on the transmitter,
• the same channel was selected on the
transmitter,
• fully charged rechargeable batteries/
disposable batteries that are not too
weak are inserted in the transmitter,
• the maximum range has not been
exceeded.
All manuals and user guides at all-guides.com
Faults
You cannot
hear your baby
or no noise is
being trans-
mitted.
You can hear
other radio
communica-
tions.
Battery does
not charge
Connection is
always brea-
king up and
there is interfe-
rence.
Devices will
not switch on.

12. Disposal

Batteries do not belong in household waste. As
a consumer, you are required by law to recycle
used batteries. You can recycle your old batter-
ies at public collection points in your community
or wherever the same batteries are sold.
22
Action
Ensure that the volume control is not tur-
ned all the way down.
As this baby monitor uses analogue
radio technology, other radio commu-
nications can cause interference. If this
happens, switch to another channel or
change the pilot tone setting.
A battery has been inserted which is not
suitable for this device.
See 5. Initial use
Check whether another technical device
such as a microwave is positioned bet-
ween the receiver and the transmitter.
Reposition the devices if necessary.
Change the batteries or connect the
devices to the mains adapter plug.