Publicidad
Idiomas disponibles
Idiomas disponibles
MOUNTING
1. Fix the mounting plate (01) at the desired place by screwing the 4 supplied
screws (08) through the 4 holes (02). The supplied screws are suitable for
wood
(picture
Alternatively, the holding fixture can be lashed e.g. around a tree trunk with a
fixing belt. A suitable belt is optionally available from DÖRR (Universal fixing
belt BG-150 black, Article No. 204497). Pull the fixing belt through the eyelets
(03) of the mounting plate
2. Screw the locking screw (07) into the lateral thread (06). Before you fully tighten
the locking screw, align the connecting plate (04) with the locking lever (05)
facing downwards.
3. Now slide your camera from above onto the connecting plate (04) until the
locking lever (05) snaps into the notch on camera housing
4. Loosen the locking screw (07) to align the camera. Afterwards tighten the
locking screw again (07).
5. To remove the camera, press the locking lever (05) slightly out of the notch and
slide the camera up.
NOTE
Changing weather conditions, exposure to direct sunlight and temperature chan-
ges can affect the colour and the material of the holding fixture can become po-
rous. These are normal material properties which are not part of the warranty.
1).
(picture
2).
08
(picture
3).
Publicidad
