Publicidad
Idiomas disponibles
Idiomas disponibles
100BMT • Detector de tensión
Safe, because detect voltage without contact.
Power supply: 2 x 1.5V AAA
Dimensions: 148 x 17 x 26 mm
Weigh: about 23g (without battery)
CAT. II 1000V according to EN61010
3. BATTERY INSTALATION
1. Open the battery door (end cap) by gently
prying up/out at the pocket clip using a small
screwdriver.
2. Insert two AAA batteries (observe polarity).
3. Replace the battery door.
NOTE: If your meter does not work properly,
check the battery to make sure if it is still good
and that it is properly inserted.
To avoid electric shock, do not operate the
meter until the battery cover is in place and
fastened securely.
The measurement must be done only with
the cap on the probe tip.
WARNING
WARNING
7
4. OPERATING INSTRUCTIONS
Risk of Electrocution. High-voltage circuits,
both AC and DC, are very dangerous and
should be measured with great care.
5. AC VOLTAGE DETECTION
Risk of Electrocution. Before using to check
for voltage in an outlet, always test the
Voltage Detector on a known live circuit to
verify that the Voltage Detector is working
properly.
Risk of Electrocution. Keep hands and
fingers on the body of the probe and away
from the probe tip.
To check AC electrical voltage in an outlet:
1.Touch the probe tip to a cord plugged into the
outlet, or insert it into the outlet hole.
2. If AC electrical voltage is present, the detector
light will flash and the audible warning will
sound.
100BMT • Detector de tensión
WARNING
WARNING
WARNING
8
Publicidad
