Installation In Vertical Sliding Windows - LD P131CMSZ0 Manual De Usuario

I N S TA L L AT I O N I N S T RU C T I O N S

INSTALLATION IN VERTICAL SLIDING WINDOWS

NOTE: The window installation kit can be used with vertical sliding windows between 460mm
and 1220mm wide.
1
Cut the foam seal A(adhesive type) &
C(adhesive type-shorter) to the proper
length, and attach it to the window sash and
frame.
Type B screws
3
Carefully lower the window. Secure the vent
panel in place with 4 type B screws, plus
one screw for each extension:
Vent panel only:
Vent panel and
one extension:
Vent panel and
two extensions:
Two vent panels and
two extensions:
14
Foam seal C
(Adhesive type-shorter)
Foam seal A
(Adhesive type)
4 type B screws
5 type B screws
6 type B screws
9 type B screws
Extension panel
(if required)
2 Insert the vent panel assembly, including
extension panels, if needed, into the window
opening. Extend the extension panels, if
used.
Foam seal B
(Non-adhesive type)
4
Cut the foam seal B(Non-adhesive type) to
the window width. Stuff the foam seal B
between the glass and the window to
prevent air and insects from getting into the
room.
Vent
Panel