Installing The Batteries - LEXIBOOK RCFOOT Manual De Instrucciones

RCFOOT- 06/01 31/07/01 18:17

INSTALLING THE BATTERIES

- Release the Velcro fastening on the bottom of the Plush Football and take out the battery compartment from inside, taking care to ensure that
you do not pull the battery connector cable too hard and break it.
- Unscrew the battery cover and lift it off from the back, to ensure that you do not break the small location lug on the battery compartment lid.
- Remove old batteries, if necessary, and insert two (2) new AA batteries. Ensure you follow the diagram marked inside the compartment to ensure
the batteries are inserted in the correct position and polarity.
- Replace and screw the battery cover back on.
- Push the battery compartment back in to the pocket on the bottom of the Puppy and seal the Velcro fastening.
NOTE:
If all batteries have been disconnected, the remote control will only retain its memory for approximately 15 minutes.
You may need to setup your remote control again if the old batteries become discharged.
This product must be powered only by the specified batteries.
Using incorrect batteries will invalidate the warranty.
Rules about batteries
- Do not use rechargeable batteries.
- Do not recharge the batteries.
- Do not mix different type of batteries, or new and used batteries.
- Remove exhausted batteries from the product immediately.
- Do not throw the batteries into a fire, they may explode and cause serious damage.
- Remove the batteries if the product is not going to be used for extended periods.
- Do not short-circuit the battery terminals.
SETTING UP THE URC (Universal Remote Control)
Mode Sounds
a) In Normal Operation - A loud "beep" sound is heard while pressing any key.
b) In Library Searching Mode - A low "beep" sound is heard while pressing any key.
Finding your TV by searching through the library
a) Turn on your TV.
b) Press and hold down both keys "CH+" and "VOL-" for about 2 seconds until the sound "beep_beep_beep" is heard.
c) Press and release the "TV" key repeatedly, slowly and patiently until the TV switches off. If no key is pressed within 25 seconds, a "beep" sound
will be heard and the URC will resume Normal Operation.
d) Press both keys "CH+" and "VOL-" again to lock in the code.
NOTE:
a) Each time you press the "TV" key, the URC will skip to the next code and transmit a POWER signal to turn off your TV.
b) If you fail to stop pressing the "TV" key when your TV has switched off, switch your TV back on again immediately. By doing this you can then
use the MUTE key to step backwards through the codes you skipped to re-find the correct code. Once you find this code repeat the procedure
in 2.d above.
c) If two "beep_beep" sounds are heard after pressing the "TV" key, that means you have already searched through all the codes contained in the
library. Press both keys "CH+" and "VOL-" to exit the Searching Mode and repeat the above procedures carefully to start searching again.
OPERATING THE URC
Once you have set up your URC, it should work like your original TV remote control. However,certain function keys may not work correctly
depending on the DEVICE CODE searched.
Page 2