_______________________________________________________________________________
4.
KEEP THE METER CLEAN. Wipe the case occasionally with a damp cloth. DO NOT use chemicals, cleaning
solvents, or detergents.
5.
USE ONLY FRESH BATTERIES OF THE RECOMMENDED SIZE AND TYPE. Remove old or weak batteries
so they do not leak and damage the unit.
6.
IF THE METER IS TO BE STORED FOR A LONG PERIOD OF TIME, the batteries should be removed to
prevent damage to the unit.
BATTERY INSTALLATION
WARNING: To avoid electric shock, disconnect the test leads from any source of voltage before removing the
battery cover.
1. Turn power off and disconnect the test leads from the meter.
2.
Open the rear battery cover by removing two screws (B) using a Phillips head screwdriver.
3. Insert the battery into battery holder, observing the correct polarity.
4.
Put the battery cover back in place. Secure with the screws.
WARNING: To avoid electric shock, do not operate the meter until the battery cover is in place and fastened
securely.
NOTE: If your meter does not work properly, check the fuses and batteries to make sure that they are still good and
that they are properly inserted.
©Copyright Abacanto Digital SA.
Manual de usuario AD9929
AD Instruments
46