Pair Your Sm100 With A Bluetooth ® Mobile Phone; Install The Realcomfort Ear Loop And Position The Sm100 Earmodule - SoundID EarModule SM100 Manual Del Usuario

2. Pair your SM100 with a Bluetooth
You must pair your SM100 EarModule with your mobile phone before using it.
1. Turn off the SM100. Turn ON the phone and navigate to "Bluetooth Link."
2. Press and hold the main button on the SM100 down for eight seconds, until
the light flashes red and green.
3. Select LOOK FOR DEVICES on the mobile phone, and then select "Sound ID
SM100" when it appears on the menu screen.
4. If asked to pair, select YES.
5. If asked for a pin, passcode or passkey, enter "0000".
6. After successfully pairing, the SM100 status light will stop flashing and the
device will remain ON.
4
® Mobile Phone 3. Install the RealComfort Ear Loop and Position the SM100
English
EarModule
There are three different Ear Loop sizes: large, medium, and small. The medium Ear Loop
comes pre-installed on the EarModule, so check its fit first. If it's not comfortable, try the
other two to find the best fit. If you need to change the Ear Loop and tip, gently pull it away
from the EarModule, then snap on the desired Ear Loop and line the tip up with the left or
right ear preference (as shown on the EarModule).
Large
Medium
(Installed on Device)
Small
English
5