GYS 025981 Manual De Uso página 14

Operating manual
- Press Select one last time to confirm.
The GYSFLASH restarts.
Switch on the Master Charger and perform the following operation to activate the "Multi-Charger" mode:
5
- Press the MODE button for 3 seconds to access the "Config-
uration" Menu
- Use the arrow keys to navigate to "Multi-Charge r mode".
- Press Select to enter the mode.
- Press Select again to activate the mode.
The Gysflash indicates its position according to the chosen con-
figuration: « SLAVE 1 » — «S LAVE 2 » — « SLAVE 3 ».
- Press Select one last time to confirm.
The GYSFLASH restarts.
A GYSFLASH configured as Slave i s locked. To return the charger to standard use,
press the key for 3 seconds, switch the "Multi-charger" mode to OFF and confirm with the key.
Connections and charge initiation:
For the SHM device to work, a GYSFLASH CNT charger must be connected to channel 1 (FIG II).
Connect the GYSFLASH to the SHM (SMC cables not supplied) according to the desired configuration.
1
Connect the power cables to the PHM (refer to the PHM manual).
2
Connect the battery to be charged to the output of the PHM.
3
Turn on all GYSFLASH.
4
Calibrate the cables.
5
Set up the charge cycle on the GYSFLASH Master.
6
Start the charge.
7
5 CABLES CALIBRATION :
Procedure for calibrating the charging cables of the device, so that the charger optimally compensates for the voltage drop due
to the cables. It is strongly recommended to perform this procedure at least once a year and each time the charging cables are
replaced.
Calibration procedure:
On the Master GYSFLASH, press SELECT to enter the CALIBRATION CABLES sub-
1
menu.
2 Short-circuit the two output clamps of the PHM.
3 Press START/STOP to start the calibration
: The calibration was carried out correctly.
4
Err19: Cable_NOK: A problem occurred during the cables calibration.
Check the wiring, the good condition of the cables and the short-circuiting. Repeat the operation.
14
Translation of the original
instructions
SMART HUB MODULE
CONFIGURATION
Multi-Charger mode
Multi-Charger mode
OFF
Multi-Charger mode
SLAVE X
SLAVE X