Munchkin Brica Smart Shade MKTR0459 Manual De Instrucciones página 5

A
C
B
D
EN. INSTALLING YOUR SHADE
1. Make sure window is clean and dry.
2. Rotate the two mounting tabs until they "click" into
the "open" position – pointing down from shade
housing. (Fig. A).
3. Insert both mounting tabs into the space between
the window and inner window seal. In some cases
it may be easier to do this with the vehicle window
in the down position. (Fig. B).
NOTE: A credit card can also work as an aid in
helping to gain access between window and inner
door window seal.
4. Lower (or raise) window so that it is a few inches
from the top of the door.
5. With one hand on the roller shade housing, pull
shade upward until the window clip can fit over the
top of the glass window with suction cup firmly in
place. (Fig C).
6. Continue to roll window up to closed position.
(Fig. D).
NOTE: Some vehicle installations may not allow the
shade to roll up and down with the window as window
shapes, sizes and door panels vary. If your vehicle does
allow you to roll the windows down, be careful not to
roll window down entirely as this will likely cause the
window clip to pop off the window.
NOTE: Do not install shade with suction cup only.
For best results, use both clip and suction cup when
installing shade.