Power Source - memorex Mi1111 Guia Del Usuario

AC CONNECTION
Unwind the AC cord and extend it to its full length. Insert
the AC plug into any convenient 120V 60Hz household
outlet. Please note that this unit is equipped with a
polarized AC plug which has one blade wider than the
other. This is a safety feature to reduce the likelihood of
electric shock. This polarized AC plug will only fit in a
polarized AC outlet. If you find that you cannot insert this
plug into your outlet, you may have an obsolete non-polarized outlet. Please do not try
to defeat this safety feature by using a non-polarized adapter or by filing the wider blade
to make it fit into your outlet. If this plug does not fit into your outlet, you should contact
a qualified licensed electrician to replace your obsolete outlet.
IMPORTANT NOTE: If there is a power failure or the AC cord is disconnected for a short
period of time, the clock will stop but the time and radio presets will be saved. When the
power is resumed or the AC cord is connected again, the clock time will continue
running and the radio presets will have been saved. However, if the power failure lasts
or the AC cord is disconnected for several minutes, the clock will be reset ("- -:- -" will
blink in the display) and you will need to set the clock and radio presets again.
REMOTE BATTERY INSTALLATION
Follow these precautions when using a battery in this device:
1. Warning - Danger of explosion if battery is incorrectly replaced. Replace only with
the same or equivalent type.
2. Use only the size and type of battery specified.
3. Be sure to follow the correct polarity when installing the battery as indicated in the
Battery Compartment. A reversed battery may cause damage to the device.
4. If the device is not to be used for a long period of time, remove the battery to
prevent damage or injury from possible battery leakage.
5. Do not try to recharge a battery not intended to be recharged; it can overheat and
rupture. (Follow battery manufacturer's directions.)

POWER SOURCE

All manuals and user guides at all-guides.com
1.
Remove the Battery Compartment (on the
bottom rear of the remote control) by
sliding the compartment out. (You can
insert a penny, or similar object, into the
groove on the compartment to help slide
it out.)
2. Install a CR2025 battery, paying attention
to the polarity diagram in the Battery
Compartment (positive side up).
3. Replace the Battery Compartment.
BATTERY PRECAUTIONS
8
AC Outlet
AC Plug