DeWalt DCST991 Manual De Instrucciones página 12

English
4. Install spindle plate 20 onto the spindle
double D shaped retaining nut
inside the base of the spindle plate.
5. Align the spindle plate hole and notch, insert a
screwdriver back into the hole and thread the new
spool housing counterclockwise. Securely tighten the
new spool housing onto the spindle
Fig. K
22
Replacing guard (Fig. l–n)
An extended coverage guard is available (sold separately)
for extra coverage if desired. Use D
guard Part Number 90624357.

WARNING:
without guard firmly in place.
1. Remove the spool assembly as described in the
Replacing Spool Assembly section.
2. Remove the 4 guard screws
Fig. L
23
3. Lift the guard off at an angle as shown in Figure M.
Fig. M
4. To attached a new guard, slide the
tab 24 of the new guard under the lip
housing 5 , then lower the back of the guard into place
as shown in Figure N.
5. Replace and securely tighten the 4 guard screws
10
21 , so the
22 on the spindle sits
21 .
21
20
WALT replacement
e
Never operate appliance
23 shown in Figure L.
23
25 of the motor
23 .
6. Replace the spool housing as described in the
Replacing Spool Assembly section.
Fig. N
25
Repairs
The charger and battery pack are not serviceable.

WARNING:
SAFETY and RELIABILITY, repairs, maintenance
and adjustment (including brush inspection and
replacement) should be performed by a D
factory service center or a D
center. Always use identical replacement parts.
Register Online
Thank you for your purchase. Register your product now for:
• WARRAnTY sERViCE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with your product.
• COnFiRMATiOn OF OWnERshiP: In case of
an insurance loss, such as fire, flood or theft, your
registration of ownership will serve as your proof
of purchase.
• FOR YOUR sAFETY: Registering your product will
allow us to contact you in the unlikely event a safety
notification is required under the Federal Consumer
Safety Act.
Register online at www.dewalt.com/register.
Three Year Limited Warranty
D WALT will repair, without charge, any defects due to
e
faulty materials or workmanship for three years from the
date of purchase. This warranty does not cover part failure
due to normal wear or appliance abuse. For further detail
of warranty coverage and warranty repair information,
visit www.D WALT.com or call 1–800–4-D
e
433–9258). This warranty does not apply to accessories
or damage caused where repairs have been made or
attempted by others. This warranty gives you specific legal
rights and you may have other rights which vary in certain
states or provinces.
In addition to the warranty, D
by our:
24
To assure product
WALT
e
WALT authorized service
e
WALT (1–800–
e
WALT appliances are covered
e