Automatic Programming - König Electronic VID-TRANS75KN Manual De Usuario

Using the remote control feature:
The system not only offers to send audio/video from one area to another, it also offers the
possibility to control a connected source by using the existing remote control of the source.
It converts the infrared (IR) signal emitted by the remote control to a radio frequency (RF)
signal in the UHF band at the receiver and sends it back to the transmitter where the RF
signal is converted back to the original IR signal and beamed to the source.
Use the IR cable and connect the 2.5mm plug to the input jack on the back of the
transmitter (IR). Place the IR sensor in front of the display of the source that needs to
be controlled. It's important to place the IR sensor as close as possible to the IR sensor,
which is behind the display, of the source.
Set up:
Before starting the set up, be sure that all connections are made and the system is
switched on.
Push the MENU button (1) on the remote control to enter the menu.
The menu offers the following options;

AUTOMATIC PROGRAMMING

MANUAL DOWN SEARCHING
MANUAL UP SEARCHING
SORTING PROGRAMS
Use the CH buttons (3) on the remote control to select an option. Push the OK button (5)
to confi rm.
AUTOMATIC PROGRAMMING
Select this option for automatic programming of all available channels (programs). The
found channels will be stored in random order. During programming the TV channels, the
display shows: CHANNEL SCANNING, PLEASE WAIT. When the scanning is fi nalized
the TV shows the fi rst channel (CH00). Push the CH buttons (3) to select a channel.
Note: automatic programming is recommended
MANUAL DOWN/UP SEARCHING
Select DOWN (downwards searching in the frequency band) or UP (upwards searching
in the frequency band) for manual programming of each channel. Push the OK button (5)
to confi rm.
VCR, DVD, SAT or other device
IR sensor in front of display
8