Nolan N90 Seguridad E Instrucciones página 17

2.3 Insert the rear right, central and left flaps of the liner into the relevant support seats in the
helmet neck-ring area (Fig. 16). To perform this step, act as follows: slightly deform the
shell sealing edge and push the flaps until they are completely hooked to the support.
2.4 Hook the fixing button located in the back of the cheek pad near the roll neck to the seat
fitted on the shellʼs internal wall (Fig 15).
2.5 Hook the roll-neck eyelet to the frame fixed to the outer shell (Fig. 14), making sure that
the frame central hole is free.
Note: Check the correct assembly of the liner front area by lifting and lowering
the VPS. These movements should be smooth. If this is not the case, repeat the
steps 1.5 and 2.2.
2.6 Insert the left chin strap in the slot of the left cheek pad by pulling towards the inside of the
helmet; then push the padding near the snap fastener on its back so that it is hooked in
the hooking seat of the frame fixed to the shell (Fig. 13).
WARNING!!!
- Remove the padding only when cleaning or washing is required.
- Never use the helmet if the inner comfort padding and the cheek pads have not been cor-
rectly and completely restored.
- Delicately hand-wash in lukewarm water (max. 30°C) and neutral soap.
- Rinse off with cold water and dry up at room temperature away from direct sunrays.
- Never machine-wash the inner comfort padding.
- The inner polystyrene is an easily deformable material, in fact it is apt to change or get
partially destroyed to help absorb shocks.
- Use a wet cloth to clean it and let it dry at room temperature away from direct sunrays.
- Do not modify the helmet's internal polystyrene components in any way.
- Never use tools or equipment of any sort to carry out the steps described above.
17