Maintenance/Cleaning; Maintenance; Replacing The 12 V Fuse; Cleaning - Crivit CEK 29 A1 Manual De Instrucciones

8. Maintenance/cleaning

8.1 Maintenance

WARNING! Maintenance work is required if the cool box
has been damaged, liquids or objects have got inside the
housing, the cool box has been exposed to rain or moisture
or if the cool box is not functioning properly or has been
dropped. If you notice any smoke, unusual noises or smells,
disconnect the cool box from the mains immediately. If this
happens, you must stop using the cool box until it has been
checked by a specialist. All maintenance work should only
be carried out by qualified specialists. Never open the
housing of the cool box.

8.2 Replacing the 12 V Fuse

Proceed as follows to replace the fuse:
 Remove the cigarette lighter socket connection [1] from the cigarette lighter socket.
 Loosen the screw on the fuse box and pull off the cap.
 Replace the fuse [11] with a new fuse [11] of the same type. You can purchase a suitable
replacement fuse [11] at an electronic goods retailer.
 Now replace the cap and tighten the screw again.

8.3 Cleaning

DANGER! Disconnect the connecting cable before
cleaning the power source. There is a risk of electric shock!
DANGER! In order to avoid risk, ensure that no liquids
enter the lid.
Remove the lid [2] for cleaning by opening it as far as it will go and then pressing it from the right
rear recess [10].
To clean the lid [2], use a slightly damp cloth and never use solvents or cleaning agents that react
with plastics. You can carefully clean the ventilation slots in the lid [2] with a soft brush.
Clean the inside of the cool box using detergent and then clean water. Dry the cool box
thoroughly.
Crivit CEK 29 A1
English - 27