DeWalt DCG416 Manual De Instrucciones página 19

ACCESSORIES CHART
5" (125 mm) grinding Wheels
Type 27 guard
Backing flange
Type 27
Depressed center
wheel
Locking flange
5" (125 mm) grinding Wheels
Type 27 guard
Type 27 hubbed
wheel
5" (125 mm) sanding Flap Discs
Type 27 guard
Backing flange
Non-hubbed sanding
flap disc
Locking flange
5" (125 mm) sanding Flap Discs
Type 27 guard
Hubbed sanding
flap disc
5" (125 mm) Cutting Wheels
Type 1/41 guard**
Backing flange
Type 27/42 depressed
center wheel,
cutting only
Locking flange
5" (125 mm) Cutting Wheels
Type 1/41 guard**
Backing flange
Type 1/41 abrasive
cutting wheel
Locking flange
5" (125 mm) Cutting Wheels
Type 1/41 guard**
Backing flange
Diamond cutting
wheel
Locking flange
Wire Wheels
Type 27 guard
3–4" (76.2–100 mm)
wire cup brush
Wire Wheels
Type 27 guard
4" (100 mm)
wire wheel
sanding Discs
Rubber backing pad
Ssanding disc
Clamp nut

Type 1/41 guards are intended for use with Type
1/41 cutting wheels and Type 27 wheels marked for
cutting only. Grinding with wheels other than Type
27 and Type 29 require different accessory guards.
Always use the smallest proper guard possible that
does not contact the accessory.
** nOTE: A Type 1/41 guard is available at extra cost from
your local dealer or authorized service center.
English
17