Regular Maintenance; Schedule; Checking Tire Pressure; Auger Gear Case Lubrication - Snapper 1226 Manual Del Operador

MAINTENANCE SCHEDULE
Maintenance Required
Check / Lubricate Free-Hand Linkage.
Lubricate snowthrower.
Check tire pressure.
Change engine oil.*
Clean or replace spark plug.
Check drive linkage/belt tension.
Lubricate Axle Shafts.
Check auger gear case lubrication.**
Lubricate Auger Shaft.***
* Change original oil after two hours of operation.
** Check oil level each fall and spring.
+ See your engine Owner's Manual.
***Lubricate each fall and spring.

CHECKING TIRE PRESSURE

The air pressure in each tire (Figure 27) should be equal
for both tires for best performance. Be sure to keep caps
on valves to prevent entry of debris into the valve stem
when tires are filled.
Size PSI
15 x 5.0-6 20
16 x 4.8-8 14

AUGER GEAR CASE LUBRICATION

1. Place the snowthrower on a level surface.
2. Remove the pipe plug (A, Figure 28).
3. Check the lubricant level. It should be level with the
lower edge of the plug opening. If not, add Benalene
grease.
4. Re-install pipe plug, and tighten securely.
All manuals and user guides at all-guides.com
+
+
bar
1,38
,96

Regular Maintenance

Frequency
10 Hours
10W Oil and Grease
10 Hours
Monthly
20 psi (1,38 bar)
50 Hours See Engine Manual
See Engine Manual
Yearly
See Page 28
4-6 Hours
Lithium Grease
Yearly
25 Hours Benalene Grease
Lithium Grease
10 Hours
Checking Tire Pressure
Auger Lubrication
25
Notes
10W Oil
Figure 27
A
Figure 28