Publicidad
EN
All manuals and user guides at all-guides.com
Install the Metal Sheet
A
1. Wipe the back of your phone case with the included alcohol prep
pad. Let dry.
2. Place the metal sheet between the phone and the case, or remove
its protective paper and stick it onto phone case.
Caution
1. Don't stick the metal sheet on the back of phone with wireless
charging functionality.
2. It is recommended to stick the metal sheet on your phone case.
Remove the phone case before wireless charging.
3. To remove the metal plate, please warm it with a hair dryer, then
use some dental floss to lift and detach it.
Install the Mount onto Your Car
B
1. Wipe the target spot with the included alcohol prep pad and wait
until it is fully dry.
2. Remove the protective paper from the base adhesive or replace it
with the spare one when needed.
3. Press the base with 3kg force onto the car dashboard and hold still
for 30 seconds.
4. Place your phone on the phone disc, adjust it for the best angle.
Caution
1. In cold weather, install the mount in a well-warmed car only.
2. Do not mount the product on the airbag.
Magnet Warning
This product contains strong magnet, which will not damage phones
or tablets with solid state hard drivers. But we strongly recommend
you to keep it away from credit cards, pacemakers, or hard drives.
Disclaimer
We do not recommend using this phone mount with older vehicles.
The dashboard of older vehicles may have become brittle due to sun
damage. We are not responsible for dashboard repair if any damage
occurs.
01/02
Publicidad
