Assembly; Operation; Boiler Description; Commissioning - Blanco Hot Boiler 4L EU Instrucciones De Uso Y De Montaje

INSTALLATION
6.

Assembly

Important
See separate instructions enclosed in the packaging.
Malfunction, property damage
Always operate the boiler with the supplied safety assembly module installed
correctly at the boiler inlet only.

OPERATION

7.

Boiler description

The hot water boiler heats up drinking water electrically. The electronic temperature
controller controls the electric heating and switches the boiler off.
The hot water boiler is protected against frost if it is connected to the power supply.
However, this does not protect the mixer tap and water connections.
8.

Commissioning

WARNING - electric shock
Only a trained technician may put the boiler into operation and they must
comply with safety regulations in doing so.
Property damage, malfunction
Do not switch on the boiler if it is not correctly installed and is not filled to
capacity with water; otherwise, you may damage the mixer tap or the boiler.
Safety assembly module function test
The safety assembly module must be tested to ensure it functions correctly after
the boiler is switched on: a small amount of water must drip into the drip cup from
the safety assembly module while the boiler is heating up (boiler LED flashes red).
If no water drips out of the safety assembly module, switch off the boiler and
check installation.
Water will no longer drip out of the safety assembly module once the boiler has
finished heating up (LED lights up red permanently).
EN
21