Kalorik USK WCL 1 Manual Del Usuario página 7

All manuals and user guides at all-guides.com
When the READY LIGHT (Green) is lit it indicates that the temperature
of your wine is at the Perfect-Temp temperature according to the
Wine Type Preset you have selected.
Manual Mode (Modifying the Default
Temperature Settings)
Your Wine Bar comes pre-programmed at the factory with
suggested serving temperatures for Reds (17°C / 63°F), Rosés (13°C /
55°F), Whites (10°C / 50°F), and Champagnes (9°C / 48°F). These
settings can be modified to suit your needs. To modify the default
temperature setting:
1. Turn on the Wine Bar by pressing the "POWER" button and select
the preset you wish to modify by pressing the "WINE TYPE" button
on either the Left or Right Zone or Both.
2. Press and hold the "POWER" button until the LCD's on the Wine
Bar start flashing.
3. Once flashing press the "WINE TYPE" button to lower the Preset
Temperature Setting by 1°C (~1.8°F) decrements. You can cycle
through to a warmer temperature just by continuing to press the
WINE TYPE button. Once you have selected the modified
temperature do not touch any buttons for approximately 5
seconds. The Red LED & Preset Temperature Bar will stop flashing
and the Wine Bar will save the new temperature for the preset
you modified.
*Note: You can change the Default Temperature Setting of the
preset at anytime by following steps 1-3 above. This new setting will
be stored until it is modified or the power to the Wine Bar is
interrupted (power failure, or by unplugging from wall. Should this
occur, the Default Preset Temperature Settings will return to the
factory programmed temperatures).