Velbus VMB4IRT Manual Del Usuario Corto página 3

In order to be able to use the VMB4IRT remote control with your device, the remote and/or your device must be confi gured in the correct way.
First, remove the 3 screws at the back of the remote and open the unit. Next, select your device from the list below and follow the appropriate setup procedure.
Note: The devices listed below are supported at time of printing. Please check www.velleman.be for an up to date list, as devices might have been added.
1. For use with the VMB4PD
• Press and hold the 'Mode'-button of the remote
• Press and hold button '3'of the remote. The indicatorled of the remote
will fl ash briefl y every 3s.
• Watch the VMB4PD closely.
• As soon as button 1 of the page you wish to control is activated,
release all buttons of the remote.
• The 3 remaining buttons of the page are controlled with button 2, 3
and 4 of the remote.
• This procedure can take a couple of minutes, depending on the ad-
dress setting of the VMB4PD
• Close the remote by means of the 3 screws
• You device is ready to be used
How to setup your remote control
2. or use with the VMB8IR / VMBGPOB / VMBGPOW
• Press and hold 'Mode'-button of the remote
• Press and hold button '2' of the remote. The indicatorled of the remote
will fl ash briefl y every 3s.
• Watch the VMB8IR / VMBGPOB / VMBGPOW closely.
• As soon as the desired channel of the VMB8IR or button 1 of the
VMBGPOB / VMBGPOW page you wish to control responds, release
all buttons of the remote.
• The 3 following channels/buttons are controlled with button 2, 3 and 4
of the remote.
• This procedure can take a couple of minutes, depending on the ad-
dress setting of the VMB8IR / VMBGPOB / VMBGPOW.
• Close the remote by means of the 3 screws
• You device is ready to be used
- 3 -