TERRAILLON ELECTRIC MANICURE-PEDICURE SET WITH NAIL DRYER
NAIL DRYER
• Check that the nail dryer is fully intact. Do not use it if it is damaged or broken.
• Whilst disconnected from the power supply, check that the switch functions properly.
• Do not use the nail dryer if the UV lamp is damaged.
NAIL FILE
How to attach fittings to pen:
• Ensure pen and related fittings are fully intact.
• Secure one of the fittings to the pen (Fig 1). When securing the fitting, make sure to correctly align it with
the body of the pen.
• Secure other fittings (Fig 2).
How to load and replace batteries:
• Slide off the cover of the battery compartment in the correct direction (Fig 3).
• Load battery(s), making sure that the polarities are correct (Fig 4).
• Replace the cover of the battery compartment (Fig 5).
• To replace used battery(s), slide off the cover of the battery compartment and remove used battery(s)
(Fig 6).
• Load new battery(s), making sure that the polarities are correct, and replace the cover of the battery
compartment (Fig 5).
IMPORTANT:
Pay attention to the force and direction of the nail file while filing nails, to avoid risk of damage to
skin/nails.
OPERATION
NAIL DRYER
• Make sure the nail dryer is switched off (Fig a).
• Place on a hard and flat surface. Connect with the power supply at the back of the device.
• Connect the plug to 220V~50Hz power.
• Press the button
• Place hand flat underneath the UV lamp and dry nails (Fig c).
• When nails are completely dry, switch off the nail dryer and unplug it from the power supply.
Fig.a
8
Notice CH-326.indd 8
INSTRUCTION MANUAL
PREPARATION BEFORE USE
to switch on the device and the UV lamp will illuminate (Fig b).
Fig.b
EN
Fig.c
N
•
•
•
w
•
P
W
T
D
o
I
4/08/11 11:28:00