Safety Warnings - Marmitek CAT4000 Modo De Empleo

SAFETY WARNINGS

• The wiring of your electrical installation is live (230 V) and extremely dangerous. Never connect the module when
plugged into the mains. Always turn off the main switch before starting the installation.
• This product is for professional use and should be installed by a certified installer."
• To prevent short circuits, this product should only be used inside and only in dry spaces. Do not expose the components
to rain or moisture. Do not use the product close to a bath, swimming pool etc.
• Do not expose the components of your systems to extremely high temperatures or bright light sources.
• In case of improper usage or if you have altered and repaired the product yourself, all guarantees expire. Marmitek does
not accept responsibility in the case of improper usage of the product or when the product is used for purposes other than
specified. Marmitek does not accept responsibility for additional damage other than covered by the legal product
responsibility.
• This product is not a toy. Keep out of reach of children.
• Do not open the product: the device may contain live parts. The product should only be repaired or serviced by a
qualified expert.
• Only connect the adapter to the mains after checking whether the mains voltage is the same as the values on the
identification tags. Never connect an adapter when it is damaged. In that case, contact your supplier.
• Automatic switching devices provide comfort, but can also be dangerous. They can surprise people or can ignite
clothing hanging over an electric heat source. Please be careful and take appropriate measures to avoid accidents.
INTRODUCTION
The phase coupler transmits Marmitek X-10 commands that enter from one phase to
the other two phases. These commands are repeated when transmitted to all
phases.
Proceed with care! Switch off the power before starting assembly.
The CAT4000 Phase Coupler/Repeater is a DIN rail module and must be installed in
a distribution box.
INSTALLATION
The phase coupler must be connected to the load end of a 3-phase miniature circuit
breaker (3p+N) with a maximum rated current of 16 A (see Figure 1).
Please note: The CAT4000 terminals are not suitable for use as branching
points to other groups or loads. Connections are, therefore, only permitted as
indicated in Figure 1.
ASSEMBLY
Proceed with care! Avoid touching live parts. Close the distribution box before
switching on the voltage.
As soon as the power is switched on again, the yellow LED (Program) will blink once
every three seconds (see Figure 2).
Function of the LEDs
LED
Program (yellow) Blinks every three seconds.
Status (green) Blinks on every transmitted data package for this phase.
Receive (red) Blinks on every received data package for this phase.
PROGRAMMING
Standard settings
The phase coupler/repeater will automatically, from its factory
settings, transfer and repeat Marmitek X-10 commands from
one phase to the other. The signals are transmitted (repeated)
to all phases at the maximum transmission level. In general,
the phase coupler will operate best in the standard setting.
However, under special circumstances it may be necessary to
change the settings.
CAT4000 3