【Notes】
The parameters of the battery should be meet with the requirements;The battery should have enough charge;
Pay attention to the orientation of the battery terminals during installation;Can not use the same size lithium
battery.
【 Power on】
●Remove the objective lens cover, ocular lens cover.
●Press button 17# andpeer through ocular lens 11#. If the internal screen lights
up and displays the icons as shown in the image, it means that the device is
working normally.
●Icon descriptions:
1.Battery level indicator
2.Numbers of photo available
3.Camera mode on
4.TF card inserted
●Observation (camera) mode is activated when the device is turned on. Normal observation and camera
operations are available.
【Power off】
In any condition, press button 17# for seconds the device will turn off automatic.
【SIGHT OBSERVATION】
●Remove the objective lens cover. In observation (camera) mode, aim the lens at the target and look at the
display screen through the ocular lens 11#.
1.Adjust the diopter ring 10# until the image on the display is clearest.
2.Turn the objective lens adjustment ring 2# until the target image on the display screen is the clearest.
●The device will automatically adjust the display screen brightness based on the average brightness level of the
central object image.
●Press button 15# 、14# can adjust the digital zoom, the electronic image magnification can be enlarge 1~5
times, till the image show on screen without any obvious mosaic.
●No auxiliary illuminator is needed in very brightness environment.
●In dark environment, when the sight cannot be seen clearly, the device will confirm the light intensity and turn on
the auxiliary illuminator automatically. The screen displays NL5 when in default value 1 condition.
●In a completely dark space, the device will automatic adjust the brightness trough auxiliary illuminator by sense
of the environment light intensity.
●The object lens equipped with optic filter. During the daily observation is better in observe effect with the filter
equipped, while in the night observation is better to take off the filter for good observation result.
【Notes】
Do not block the light of the auxiliary illuminator.
【Screen brightness adjustment】
Under observation (camera,video recording mode) condition, long-pressing
button 16#Enter the screen brightness adjustment function menu, show as
the image. The number beside 'Bright' index the current screen brightness level.
●Press the up button 14# or the down button 15# to adjust the brightness level
from 1 to 9, level 9 is the brightest.
【Lighting adjustment】
Under observation (camera, video recording mode) condition,long-pressing
button 16#
●Enter the auxiliary illuminator brightness Adjustment
menu, show as the image. The number beside 'lamp' indexes the light intensity
level of the auxiliary illuminator.
●Press up button 14# or the down button 15# to adjust the auxiliary illuminator
brightness level from 0 to 9. Level 9 is the brightest, level 0 indicates the auxiliary
illuminator not open to light up yet
●Turn on the light, when the quit from the menu interface, on the screen right
bottom side will appear 'NL X' , and the 'X' index the level of the auxiliary illuminator.
2
1
2 3
03727 SD
*
Bright:7
Lamp: 5
Time set
SD
03727
Bright:7
*
Lamp: 5
Time set
03727
SD
4