Focus Electrics DUAL ICE SHAVER Manual De Instrucciones página 5

1. If using paper cone cups, push Cup Holder into opening on front of Ice Shaver
Housing. If using regular cups, do not attach Cup Holder.
2. Place filled Syrup Bottles into the Syrup Bottle Holders located on the side of the
Ice Shaver Housing. Note: Keep the pump spouts turned in toward the front of
the appliance when not in use to prevent accidental dispensing of syrup.
3. Place the Auger inside the Exterior Bowl. Lock the Auger in place with the
Securing Nut by turning nut clockwise.
4. Line up the two outside tabs of the ice container assembly with the matching
grooves on the Ice Shaver Housing. Push gently in place to secure.
5. Select 1 or 2
the side of the Exterior Bowl.
6. Place paper cone cups in Cup Holder. If using regular cups, place cups on the
Base Drip Tray circular indentations to insure correct placement under the
shaving blades.
7. Add ice cubes to Auger.
8. Plug the Ice Shaver into a 120-volt AC electric outlet only.
9. Place the Lid on top of the Exterior Bowl. Turn the Lid counter-clockwise until
the large extended lid tab engages the interlock switch. The motor will start and
the ice will begin shaving.
10. To stop shaving ice, turn the Lid clockwise to disengage the motor switch.
11. To dispense syrup, turn the Pump Spouts outward, away from the appliance.
Place snow cone cup filled with shaved ice under the syrup dispenser spout and
press down approximately 5 to 7 times. Note: The number of pumps depends
on the amount of ice being used and the sweetness desired.
12. Turn the Pump Spouts toward the front of the appliance to secure. Note: Syrup
Bottles may be removed from the ice shaver and stored separately in the
refrigerator beween uses.
13. Unplug from power supply immediately after use. Note: There will always be a
small amount of ice remaining in the Exterior Bowl after shaving. Discard the
remaining ice.
CAUTION: Do not run ice shaver continuously for longer than 5 minutes as
overheating may occur. Allow motor to cool down before repeat usage.
All manuals and user guides at all-guides.com
snow cones by turning the Blade Switch Knob located on
5