Troubleshooting Guide; Need More Help - RCA DRC99373E Manual De Instrucciones

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

Maintenance

Cleaning the Disc

A defective or soiled disc inserted into the unit can cause sound to drop

out during playback.

Handle the disc by holding its inner and outer edges.

• Do NOT touch the surface of the unlabeled side of the disc.

• Do NOT stick paper or tape on the surface.

• Do NOT expose the disc to direct sunlight or excessive heat.

• Clean the disc before playback. Wipe the disc

from the center outward with a cleaning cloth.

• NEVER use solvents such as benzine or alcohol

to clean the disc.

• Do NOT use irregular shaped discs (example: heart shaped,

octagonal, etc.). They may cause malfunctions.

Cleaning the Unit

• Be sure to turn the unit off and disconnect the AC power adapter

before cleaning the unit.

• Wipe the unit with a dry soft cloth. If the surfaces are extremely

dirty, wipe clean with a cloth that has been dipped in a weak soap-

and-water solution and wrung out thoroughly, then wipe with a dry

cloth.

• Never use alcohol, benzine, thinner, cleaning fluid or other

chemicals. Do NOT use compressed air to remove dust.

Important Note

• Before transporting the unit, remove the disc from the disc

compartment.

All manuals and user guides at all-guides.com

No power.

• Ensure the AC power adapter is connected.

• The unit is not turned on.

No sound or only a very low-level sound is heard.

• The volume control is located on the side of the unit – please try

• The system is in pause mode. Press the

• The unit is in fast-forward or fast-reverse mode. Press the

• Make sure the AUDIO/VIDEO output connections are correct.

• The DTS DVD cannot be decoded to have speaker output.

• The unit is too hot; shut off the unit for 30 minutes to cool it down.

No picture.

• The region number of the disc doesn't match the region number of

The picture is not clear.

• Clean the disc.

• The disc is scratched.

Severe hum or noise is heard.

• The plugs and jacks are dirty. Wipe them with a cloth slightly

• Clean the disc.

The disc does not play.

• There is no disc inside ("No Disc" appears on the screen).

• Insert the disc correctly with the playback side facing down.

• Clean the disc.

• A non-NTSC disc has been inserted. The unit and disc region

• Condensation may have formed inside the unit due to a sudden