Mounting, Start-Up - Junt SV-SERVER-01 Manual De Operación

USA
Mounting
Mounting takes place using the supplied retaining unit on the wall or on a support rail according
to DIN EN 60715. The server is snapped onto the retaining unit.
This device has to be supplied by either:
external delivered power supply
or
external certifi ed power supply Class 2
Rated 12 V DC, 500 mA (min.)
Start-up
A current HTML5-compatible browser (input device) is required for access to SV-Home and
SV-Control.
Smart Visu Server, interface, network router (DHCP active) and input device
must all be part of the same network. During start-up, the Smart Visu Server expects the assig-
nment of an IP address via DHCP.
Remove the discharge protection (6) from the server. Connect the server to the network (2) and
the power supply unit to the server (3).
After the mains plug has been connected, the server will boot.
As soon as the Status LED (4) turns blue, the server is ready for operation.
In the address line of the Internet browser, enter:
http://sv-server.local
This opens the homepage of the server.
If the homepage is not opened, then determine the IP address of the server in the router ma-
nually. Enter the determined address, e.g. 192.168.178.26, in the address line of your Internet
browser, e.g.:
This opens the homepage of the server.
8
All manuals and user guides at all-guides.com
CAUTION