ECS Electronics REN-037-B Guia De Inicio Rapido página 3

1.
Remove battery earth cable.
Remove the covering from the right side of the boot.
2.
Route the wiringharness from the socket under the vehicle to the bonnet. Fit the electrical wiring harness to the original wiring of the car with
the delivered wire ties and mount the socket on the towbar plate.(Warning!!! Exhaust)
Trailer lighting:
Left turn signal
Rearfoglight
Earth
Right turn signal
Right taillight
Brakelights
Left taillight
Rearfoglight
3.
On the left side of the motorcompartment, there is a black fusebox located. Open it and fit the grey connector of the wiring harness which has
red, green, yellow, black and brown wires to the grey connector of the car (Renault's reference: R276)
4.
Behind the back side panel on the right side of the boot, in the bottom, there is a circular cap. Drill a 20 mm hole in the cap.
Fit the rubber grommet in the hole.
Let the wiring harness with the blue and grey wires and the two white wires trough this hole come in.
Fit the ends with the blue and grey wires to the blue connectors of the wiring harness.
Connect these connectors to the blue connectors of the car which are located behind the jack and fit the blue connectors with the delivered wire
ties and tape the sticker foreseen against the noise behind the free connectors.
Fit the white wire to chassis earth.
5.
Reconnect the battery and check all electric functions, with trailer/caravan connected.
Reinstall disassembled parts.
©ECS2000
FITTING INSTRUCTIONS ELECTRIC WIRINGKIT TOWBAR WITH 12-N SOCKET UP TO
DIN/ISO NORM 1724
Renault Espace 1997-1999
Partno.: REN-037-B
Pin No.: Wire colour:
1 (L) yellow
2 (54-G) blue
3 (31) white 2,5 mm2
4 (R) green
5 (58-R) brown
6 (54) red
7 (58-L) black
8 (58-b) grey
REN-037-B-E 220200L
1
8
STOP
2 6
7
3
5
4
REVISIE 0