Connecting A Computer - Klark Teknik VNET2-DANTE BRIDGE Guia De Inicio Rapido

24
VNET2-DANTE BRIDGE

Connecting a Computer

You can connect your computer to the Dante Bridge in one of two ways:
• • By direct connection from the Ethernet port of your computer to the Dante Bridge
• • By connecting your computer to an Ethernet switch, and connecting the same switch
(or another switch on the same network) to the Dante Bridge
Computer
Audio 2
Ethernet
Computer
Ethernet PoE Ethernet Interface
Manual IP addressing is not required with the Dante Bridge. It is set by default to DHCP, so your
DHCP server will automatically allocate the IP address. If there is no DHCP server, it will use
"zero config". In either case, addressing is fully automatic. For more information on this topic,
please refer to information pertaining to automatic configuration on the Audinate web site.
Devices
VNET VNET
In Link In Link
EXT
Audio 1 Dante VNET A
Dante Bridge Power supply
Devices
VNET VNET
In Link In Link
Audio 2 Audio 1 Dante VNET
Dante Bridge
PodWare Setup
The PodWare application uses a direct connection via Ethernet to communicate with the
connected devices via the Dante Bridge.
Using PodWare V5.68 or later, select and add the Dante Bridge network under the Networks ->
Add Networks dialogue.
You can connect multiple Dante bridges to PodWare via Ethernet. The Bridges will be
transparent to PodWare and the devices will appear under the Dante Bridge network in the
device tree.
B
EXT
25
Quick Start Guide