Axxess AX-ADFD02 Instrucciones De Instalación

INTERFACE FEATURES
• Provides accessory power (12-volt 10-amp)
• Maintains the retained accessory power (R.A.P.) feature
• Provides NAV outputs (parking brake, reverse, speed sense)
• Retains SYNC
• Retains the factory AUX-IN jack
INTERFACE COMPONENTS
• AX-ADFD02 harness
APPLICATIONS
See inside front cover
AxxessInterfaces.com
All manuals and user guides at all-guides.com
Ford Data Interface
*Visit AxxessInterfaces.com for up-to-date vehicle specific applications.
INTRODUCTION
The AX-ADFD02 harness is designed for, and must be used with, the
AX-ADBOX1 or AX-ADBOX2 interface (sold separately). Please refer to the
AX-ADBOX1 or AX-ADBOX2 for the 16-pin connector with stripped leads.
• Pre-wired ASWC-1 harness (ASWC-1 sold separately)
• Designed for non-amplified models
• Retains balance and fade
• Micro "B" USB updatable
© COPYRIGHT 2018 METRA ELECTRONICS CORPORATION
2011-up*
AX-ADFD02
I N S TA L L AT I O N I N S T R U C T I O N S
TABLE OF CONTENTS
Connections to be made .......................................3
Installing & programming the AX-ADFD02
AX-ADBOX1 ...........................................................4
AX-ADBOX2 ..........................................................5
Extra features .........................................................6
TOOLS REQUIRED
• Crimping tool and connectors or solder gun,
solder, and heat shrink • Wire cutter • Zip ties
CAUTION! All accessories, switches, climate
controls panels, and especially air bag indicator
lights must be connected before cycling the
ignition. Also, do not remove the factory radio
with the key in the on position, or while the
vehicle is running.
REV. 6/27/18 INSTAX-ADFD02