Coupling Requirements; Safety Instructions - Spinder XPLORER+ Manual De Montaje

COUPLING REQUIREMENTS

WARNING!
Personal injury is possible due to breakage of the trailer coupling.
The coupling could break if the bicycle carrier is fitted to a coupling made
of a too soft material.
 Fit the bicycle carrier only to a coupling made of steel St52, grey cast
iron GG52 or higher quality.
 Never fit the bicycle carrier to a coupling made of aluminium, other
light metals or plastic.
 Only suitable for use on the coupling of a passenger car.
Fit the bicycle carrier only to trailer couplings with the
following properties:
Material:
D-value:
Tow ball:
Note the instructions of the coupling manufacture.

SAFETY INSTRUCTIONS

Follow the fitting instructions carefully. Failure to follow the instructions can lead
to personal injuries and material
damage.
If you are not sure about correct fitting, ask your dealer or the manufacturer for
further information. Neither the manufacturer nor dealer are liable for damages
which are due to improper use or fitting.
Check the bicycle carrier and the load regularly: you are required to do so and
may be held liable in case of damage.
NOTE
The legal regulations and provisions on the transport of goods on the back
of your vehicle apply when driving with a mounted bicycle carried.
WARNING!
Personal injury or material damage due to changed vehicle driving
characteristics.
Driving with the bicycle carrier fitted will affect the driving characteristics
of your vehicle.
 Adjust your speed to the new driving characteristics.
 Never exceed a speed of 130 km/h.
 Avoid sudden and jerky steering movements.
 Remember that your vehicle is longer than usual.
min. steel St52 or grey cast iron
GG52
>7,6 kN
Ø50mm (class A-50 according
EC 94/20 or ECE R55)
50