Cub Cadet 45-03293-100 Manual Del Usuario página 7

OPERATION
HOw TO USE YOUR SPREADER
SETTING THE FLOw CONTROL
(Refer to figure 9 on page 6.)
1. Loosen the nylon wing nut, set the adjustable stop to
the desired flow rate setting and retighten the wing nut.
The higher the setting number, the wider the opening
in the bottom of the hopper.
2. Refer to the application chart on this page and to the
instructions on the fertilizer bag to select the proper flow
rate setting.
3. Pull the flow control arm against the adjustable stop
for the on position and toward the hopper for the off
position.
THE FREE wHEELING FEATURE
(Refer to figure 4 on page 5.)
The spreader is equipped with a removable pin in the left
(drive) wheel. Remove the pin to disengage the drive wheel
so that the axle, gears and spreader plate do not rotate. With
the drive wheel disengaged, the spreader may be towed at
speeds up to 20 mph. If the drive wheel is engaged do not
exceed 6 mph.
USING YOUR SPREADER
We do not recommend the use of any powdered lawn
chemicals, due to difficulty in obtaining a satisfactory or
consistent broadcast pattern.
1. Determine approximate square footage of area to be
covered and estimate amount of material required.
2. Before filling the hopper make sure the flow control arm
is in the off position and the closure plate is shut.
3. Break up any lumpy fertilizer as you fill the hopper.
4. Set the adjustable stop with the flow control arm still in
the off position. Refer to the application chart on this
page and to the instructions on the fertilizer bag to select
the proper flow rate setting.
5. The application chart is calculated for light to heavy
application at a vehicle speed of 3 mph, or 100 ft. in 23
seconds. A variation in speed will require an adjustment
of the flow rate to maintain the same coverage. The
faster you drive, the wider the broadcast width.
6. Make sure the drive pin is installed in the axle before
starting the spreader.
7. Always start the tractor in motion before opening closure
plate.
8. Always shut the closure plate before turning or stopping
the tractor.
9. If fertilizer is accidentally deposited too heavily in a small
area, soak the area thoroughly with a garden hose or
sprinkler to prevent burning of the lawn.
ENGLISH
10. To insure uniform coverage, make each pass so that the
broadcast pattern slightly overlaps the pattern from the
previous pass as shown in figure 12. The approximate
broadcast widths for different materials are shown in
the application chart on this page.
11. When broadcasting weed control fertilizers, make sure
the broadcast pattern does not hit evergreen trees,
flowers or shrubs.
12. Heavy moisture conditions may require a cover over the
hopper to keep contents dry. The vinyl cover acts as a
wind and moisture shield, but should not be used as a
rain cover.
REFER
TO
CHARTS
OVERLAP
FIGURE 12
IMPORTANT: Application rates shown in the chart are
affected by humidity and by the moisture content of
the material (granular and pellet). Some minor setting
adjustments may be necessary to compensate for this
condition.
TYPE
MATERIAL
FERTILIZER
Powder
Granular
Pelleted
Organic
GRASS SEED
Fine
Coarse
ICE MELTER
OPERATING SPEED - 3 MPH. (100 ft. in 23 seconds)
7
APPLICATION CHART
FLOW SETTING
3 - 5
3 - 5
3 - 5
6 - 8
3 - 4
4 - 5
6 - 8
SPREAD
WIDTH
3' - 4'
8' - 10'
10' - 12'
6' - 8'
6' - 7'
8' - 9'
10' - 12'