Technical Specifications - BMR 390 Manual De Usuario

technical specifications

Caring for your
ACTIVATOR
Your should not be allowed to get wet or be left in excessive sunlight. It
ACTIVATOR
may be cleaned regularly using a soft cloth, lightly dampened in soapy water. Do
not allow the interior of your
ACTIVATOR
alcohol, spray aerosols or strong solvents on your
Access to the interior of the
ACTIVATOR
If your is damaged, you should not use it but should return it to
ACTIVATOR
your local distributor for replacement or repair. Repairs, service and modifications
may not be carried out by anyone other than qualified service personnel authorised
by .
BMR
: Under no circumstance should anything other than the correct type of
IMPORTANT
batteries – (rechargeable battery pack, 3.6V NiMH) be used with your
These can be purchased from the Careline.
Disposing of the batteries
Used batteries must never be disposed of in a fire but in accordance with state or
national laws governing the disposal of such items.
: The signal gradually increases to a peak intensity level at the start of the
NOTE
contraction phase (i.e. ramp up) and gradually decreases to nothing at the start
of the relaxation phase (i.e. ramp down). When the of the relaxation phase (i.e. ramp down). When the
stimulus is significantly reduced.
Product t ype: 390
Classification: Internally powered equipment, Class II charger, Type BF applied parts.
Intended use: Muscle stimulator
Waveform: Symmetrical bi-phasic square waveform when measured into a
resistive load.
10
to become wet. Do not use detergents,
.
ACTIVATOR
is not required for maintenance purposes.
ACTIVATOR
symbol is flashing, the symbol is flashing, the
Beauty Series Accessories:
You can purchase all accessories at www.bmrbeautyseries.com. Under no
circumstances should anything other than
ACTIVATOR FOR LIFT
the product and could degrade the minimum safety levels.
Garment (E:70)
BMR TUMMY LIFT
GelPads:
BMR TUMMY LIFT
BMR BOTTOM LIFT
or
BMR
BMR BOTTOM LIFT
Garments (E:60)
BMR ARM LIFT
GelPads:
BMR ARM LIFT
Belt Extender
Battery pack (3.6V, NiMH)
. Battery Charger (EU - 2504-0303)
Battery Charger (US/Japan - 2504-0302)
Charger complies to EN 60950, Input: nominal voltage 100-240V, frequency 50-60Hz,
current 125mA. Do not use any other chargers or any other power supplies.
Environmental Specifications:
Operating: Temperature Range: 0 - 35°C (32 - 95°F)
Humidity:
Storage: Temperature Range: 0 - 35°C (32 - 95°F)
Humidity:
Description of your
There are a number of technical markings on your
as follows:
The
ACTIVATOR
Parkmore Business Park West, Galway, Ireland.
The requires 1 x 3.6 volt (NiMH) DC battery pack. DC is indicated by
ACTIVATOR
the symbol:
accessories be used with your
BMR LIFT
(Type 390) or charger. Any others may not be compatible with
•1 large GelPad (Type 706 or 709)
•2 small GelPads (Type 707 or 710)
Garment (E:30)
GelPads: •4 large GelPads (Type 716)
•4 small GelPads (Type 715)
20 - 65 % RH
20 - 85 % RH
's symbols:
ACTIVATOR
ACTIVATOR
and garments are manufactured for Bio-Medical Research Ltd,
. These can be explained
11